[Francais]

Попробуи такзе вот ето: _http://www.4pcsoft.com/Download/d14615.htm

добавлено через 3 минуты
Это последнее чем я способен помоч:

In short: Go into Device-Manager and Select IDE ATA/ATAPI controllers: Try changing to "PIO Only" mode instead of "Ultra DMA Mode" on the IDE Channel which your DVD-Drive is using, namely the Secondary IDE Channel (since the 1st is probably your disk). It should say "Location 1" on the tab of where the drive is NOT zero.

Ultra-DMA is obviously newer and faster and better, but I think that it still gets the specified performance from the PIO-mode. Took me around 10 minutes to write around 3 gigs.

(1) uninstalled manually every device driver which looked even remotely connected to "Matshita" or "DVD" or "CD" INCLUDING "Standard Dual Channel PCI IDE Controller" and "Secondary IDE Channel".

(2) ensured a hard restart (power-off)

(3) allowed Windoze to auto-detect whatever hardware it pops up after reboot commences

(4) one of those items was the "Secondary IDE Channel"... or in any case... go into Control Panel->System->Hardware : Secondary IDE Channel.
(a) Change from "Ultra DMA mode" to "PIO Only mode"

(5) Go back into the Control Panel->Hardware->Device Manager->IDE ATA/ATAPI controllers->Secondary IDE Channel : Transfer Mode = "PIO Only" to make sure that this reinstallation you just experienced kept that setting, if not, set it as such, and again, DO NOT change your "location 0" setting, the tab displaying your secondary ide channel should say "location 1".

(5) hard-reboot again

(6) system should come up and auto-detect your CD-ROM / DVD-ROM / Optical Drive / DVD-RAM drive all at once on the next restart.

It should then function.