Цитата:
|
Если не лень самому паять - то здесь:
|
Здесь -где?Не нашёл я ТАМ(по ссылке) схемы переходника!
Если это она:
How can RecAll-PRO be used to record telephone conversations? We now use the Telephone Recording Control (43-228A) from Radio Shack.
Prior to discovering this device, we built the following circuit, which seems to work adequately (for USA type telephone lines) (soon to be a gif file for better readability, but until then make sure your browser window is wide enough so the lines don't wrap around):
Phone ||C1 R1 T1 R2 sound card
Tip-----||------/\/\/--+ +-----/\/\/----+-------+------mike-input
|| | | | D1 | D2 tip
) || ( ----- ----
) || ( /\ \ /
) || ( / \ \/
) || ( ---- -----
Phone ||C2 | | | | sound card
Ring----||-------------+ +--------------+-------+------mike-input
|| outer ring
(RS means Radio Shack nearest-equivalent part number)
R1,R2 10kohm,1/2watt (RS271-1126)
C1,C2 .1uF, >200V (RS272-1053)
T1 600ohm 1:1 telephone audio transformer (RS273-1374)
D1,D2 generic signal diodes (RS276-1653)
Telephone tip and ring are the two center conductors of a four-conductor modular telephone connector, and for this circuit it doesn't matter if they are reversed. (RS279-391)
Sound card microphone-input connector is a 1/8" 3-conductor audio male plug. (RS274-284C)
То это для американского стандарта,для наших(финских диги-атс)врядли прокатит.И описалова нормального нету.Или мне ктото объяснит?